Guide.LilyPadMacOSX History

Hide minor edits - Show changes to markup

February 05, 2013, at 01:05 AM by Leah Buechley -
Added lines 70-76:

11 | Additional Resources

  • lilypadarduino.org: a comprehensive guide to getting started with LilyPad
  • LilyPad Category on SparkFun: sensors, actuators, and other boards for use with the LilyPad Arduino

February 05, 2013, at 01:00 AM by Leah Buechley -
Changed lines 64-65 from:

Now, simply click the "Upload" button in the environment. Wait a few seconds - you should see the RX and TX leds on the FTDI board flashing. If the upload is successful, the message "Done uploading." will appear in the status bar.

to:

Now, click the "Upload" button in the environment. Wait a few seconds - you should see the RX and TX leds on the FTDI board flashing. If the upload is successful, the message "Done uploading." will appear in the status bar.

February 05, 2013, at 12:59 AM by Leah Buechley -
Changed lines 66-67 from:

A few seconds after the upload finishes, you should see the pin 13 LED on the board start to blink (in green). If it does, congratulations! You've gotten your LilyPad Arduino up-and-running.

to:

A few seconds after the upload finishes, you should see the LED on the board start to blink (in green). If it does, congratulations! You've gotten your LilyPad Arduino up-and-running.

February 05, 2013, at 12:04 AM by Leah Buechley -
Added lines 1-70:

Share