Tutorial.GSMExamplesWebClient History

Hide minor edits - Show changes to markup

March 11, 2013, at 10:37 AM by Scott Fitzgerald -
Changed lines 245-258 from:
to:
February 04, 2013, at 09:15 AM by Scott Fitzgerald -
Changed lines 71-72 from:

When the modem does connect nd had attached itself to the GPRS network, gsmAccess() will return GSM_READY. Use this as a flag to set the notConnected variable to true or false. Once connected, the remainder of setup will run.

to:

When the modem does connect and has attached itself to the GPRS network, gsmAccess() will return GSM_READY. Use this as a flag to set the notConnected variable to true or false. Once connected, the remainder of setup will run.

February 02, 2013, at 11:03 AM by Scott Fitzgerald -
Changed lines 1-6 from:

Examples > Make Voice Call

Using the GSM Shield to Make Calls

This example shows how to use the GSM Shield and Library to make voice calls. Please click here for more information on the GSM library.

to:

Examples > GSM library

GSM Web Client

This sketch connects an Arduino to the Arduino homepage, http://arduino.cc, through a GSM shield. It then prints the content of the page through the serial monitor.

Changed line 11 from:
  • SIM card
to:
  • SIM card with a data connection
Changed lines 23-25 from:

The code below is configured for use with a GSM/GPRS shield. In the variable declaration area, you need to instantiate both the GSM and GSMVoiceCall classes. Inside setup(), call GSM.begin(), with the PINNUMBER of your SIM card as parameter. GSM.begin() will return whether the shield managed to connect to the GSM network or not.

In the loop(), the input from the Serial Monitor is used to tell the GSM Shield a phone number to call to. The code waits until the call is over before performing any other actions.

to:
Changed lines 140-239 from:
to:
Changed line 245 from:
to:
November 16, 2012, at 07:58 PM by Scott Fitzgerald -
Added lines 1-34:

Share