Ethernet Shield Network Time Protocol (NTP) Client

Query a Network Time Protocol (NTP) server using UDP.

Tutorials > Examples > Ethernet > UdpNtpClient

In this example, you will use your Ethernet Shield and your Arduino to query a Network Time Protocol (NTP) server. This way, your Arduino can get the time from the Internet.

Hardware Required

Circuit

The Ethernet shield allows you to connect a WIZNet Ethernet controller to the Arduino boards via the SPI bus. It uses the ICSP header pins and pin 10 as chip select for the SPI connection to the Ethernet controller chip. Later models of the Ethernet shield also have an SD Card on board. Digital pin 4 is used to control the chip select pin on the SD card.

The shield should be connected to a network with an Ethernet cable. You will need to change the network settings in the program to correspond to your network.

The circuit for this tutorial.
The circuit for this tutorial.

Image developed using Fritzing. For more circuit examples, see the Fritzing project page

In the above image, the Arduino board would be stacked below the Ethernet shield.

Schematic

The schematic for this tutorial.
The schematic for this tutorial.

Code

Last revision 2018/09/07 by SM

Suggest changes

The content on docs.arduino.cc is facilitated through a public GitHub repository. If you see anything wrong, you can edit this page here.

License

The Arduino documentation is licensed under the Creative Commons Attribution-Share Alike 4.0 license.