Thanks for replies all -
Timebase was set to 0.1 ms
As i mentioned before the sketch is the standard 'knob' which comes with the software. Im using an UNO running the servo from a separate bench supply to the Arduino . I want to be able to get three of these babys running independently of each other eventually!
knob sketch =
#include <Servo.h>
Servo myservo; // create servo object to control a servo
int potpin = 0; // analog pin used to connect the potentiometer
int val; // variable to read the value from the analog pin
void setup()
{
myservo.attach(9); // attaches the servo on pin 9 to the servo object
}
void loop()
{
val = analogRead(potpin); // reads the value of the potentiometer (value between 0 and 1023)
val = map(val, 0, 1023, 0, 179); // scale it to use it with the servo (value between 0 and 180)
myservo.write(val); // sets the servo position according to the scaled value
delay(15); // waits for the servo to get there
}
I basically want to use the knob sketch but with 3 separately controlled winch servos.
Ill try the zoomkat code thanks for that -
I don't really understand how it can be that difficut to control the servos, surely you can edit the knob sketch to house more than 180 rotation??