I went trying out my LED by connecting it to the 5V and the ground pin ( 2k ohm resistor is also present ). Suddenly, the LED was just flickering and died out. I was running one of my self-programmed 'reset' mode below. But how come this could happen? void setup() { ; } void loop() { ; }

Need some help!!

system July 5, 2011, 12:04pm 2

What are the chances of two people having the same problem?
Amazing.

Topic		Replies	Views
Need some help!! General Electronics	9	2842	May 6, 2021
LED flickering by itself... hmm, why ? Programming Questions	8	1760	May 5, 2021
Arduino pins not lighting up led IDE 1.x	6	7256	May 5, 2021
Blink - Flickering??? Frequently-Asked Questions	13	4322	May 6, 2021
LED is behaving weirdly even though I did everything that I'm supposed to do. IDE 1.x	2	475	May 5, 2021