Arduino - DigitalWrite

Questo sito non è ne attivo ne aggiornato, specialmente la pagina del download è ferma a 5 vesioni fa , utilizzate il sito in inglese finchè questo sito non sarà annunciato ufficialmente

Reference Language (extended) | Libraries | Comparison | Board

digitalWrite(pin, value)

Description

Write a HIGH or a LOW value to a digital pin. If the pin has been configured as an output with pinMode(), its voltage will be set to the corresponding value: 5V (or 3.3V on 3.3V boards) for HIGH, 0V (ground) for LOW.

If the pin is configured as an input, writing a HIGH value will enable an internal 20K pullup resistor. Writing LOW will disable the pullup.

Parameters

pin: the pin number (int)
value: HIGH or LOW

Returns

none

Example

 
int ledPin = 13;                 // LED connected to digital pin 13

void setup()
{
  pinMode(ledPin, OUTPUT);      // sets the digital pin as output
}

void loop()
{
  digitalWrite(ledPin, HIGH);   // sets the LED on
  delay(1000);                  // waits for a second
  digitalWrite(ledPin, LOW);    // sets the LED off
  delay(1000);                  // waits for a second
}

Sets pin 13 to HIGH, makes a one-second-long delay, and sets the pin back to LOW.

Note

The analog input pins can also be used as digital pins, referred to as numbers 14 (analog input 0) to 19 (analog input 5).